DO run wheel in a protected area for one minute before grinding. DO wear ANSI Z87+ safety glasses and additional eye and face protection, if required. DO employ dust controls and/or protective measures appropriate to the material being ground.
Grinding is the main machining process for producing glass workpieces. However, cutting forces during grinding result in the formation of damaged surfaces which require a polishing operation to ...
· Do not remove the factory safety guards off the grinder. They are there for a reason. The angle grinder safety guards can greatly reduce the accidents that occur from shattered abrasive discs.
Always wear safety gear when sharpening glass with a bench grinder As you work on the ground glass, you must put on safety goggles. This is because this process produces a lot of glass dust files as well as glass chips all over, which can cause severe injury to your eye .
· Place the sharp edge of the glass against the plate glass. Grasp the piece of glass with your dominant hand (or with both hands, if needed). Be sure to place the glass edge directly over the spot where you mixed the silicon carbide with the water. For maximum safety, wear safety gloves to avoid cutting your hands on the glass.
Grinding Safety Glasses. Cutting or grinding metal poses a risk not only to your hands, but your eyes as well, making it of the utmost importance to choose the right protective eyewear for the task. There are many safety glasses that can shield your eyes from hazardous debris, ...
· The following points cover some basic but very important grinding safety measures. Avoid using any loose jewelry while grinding. Unplug the power cord before you mount or remove the wheel. Avoid grinding nonferrous materials.